Avaya G430 Manual page 72

Basic device configuration
Example for setting reset times
If there are three IP addresses in the MGC list and the third address is the LSP, the transition
point should be 2.
The default time for the primary search is one minute. The default time for the total search is
30 minutes. The default transition point is 1.
Example
Gxxx-001(super)# set reset-times primary-search 20
Done!
Gxxx-001(super)# set reset-times total-search 40
Done!
Gxxx-001(super)# set reset-times transition-point 1
Done!
In this example, in the event of a connection loss with the registered MGC, the Branch Gateway
searches for the primary MGC on its MGC list for 20 minutes. If the Branch Gateway does not
establish a connection with the primary MGC within this time, it searches for the other MGCs
on the list for a total of 40 minutes.
Accessing the registered MGC
Procedure
Access the MGC according to the following:
a. If the MGC is an S8300 Server, enter session mgc
b. If the MGC is an S88xx, Dell or HP, use the set mediaserver command to
c. If the Branch Gateway includes a local S8300, enter session icc to access the
d. To open a connection directly to the Avaya Aura
e. To open a connection to the MGC's LINUX operating system, do not add sat to
72 Administering Avaya G430 Branch Gateway
The session mgc does not work on an IPv6–only Branch Gateway.
manually define the MGC's IP address, and then enter session mgc to access
the MGC.
S8300. You can use this command whether or not the local S8300 is the Branch
Gateway's registered MGC.
Both the session mgc command and the session icc command open a telnet
connection to the MGC.
Use the session mgc on an S8300D running VSP.
System Access Terminal (SAT) application in the MGC, add sat to the
command.
For example:
Gxxx-001(super)# session mgc sat
the command.
Comments? infodev@avaya.com
®
Communication Manager
October 2013