Avaya G430 Manual page 460

The router
For example, to add a static ARP table entry for station 192.168.7.8 with MAC address
00:40:0d:8c:2a:01, use the following command:
Gxxx-001# arp 192.168.7.8 00:40:0d:8c:2a:01
Changing an entry in the ARP table
Procedure
To change an entry in the ARP table, delete the entry and reinsert it with revised
parameters.
Summary of ARP table commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Command
arp
no arp
arp timeout
no arp timeout
clear arp-
cache
ip max-arp-
entrie s
no ip max-arp-
entrie
show ip arp
460 Administering Avaya G430 Branch Gateway
Add a permanent entry to the ARP table
Remove either a static entry or a dynamically-learned entry from the
ARP table
Configure the amount of time, in seconds, that an entry remains in
the ARP table
Entering this command without a time parameter displays the current
timeout value.
Restore the default value (four hours)
Delete all dynamic entries from the ARP table and the IP route cache
Specify the maximum number of ARP table entries allowed in the
ARP table
Restore the maximum number of ARP table entries allowed in the
ARP table to default value
Display a list of the ARP resolved MAC to IP addresses in the ARP
table
Comments? infodev@avaya.com
Description
October 2013