Avaya G430 Manual page 116

Standard Local Survivability (SLS)
Contact closure / SLS feature interactions
• There is no screening to authorize the use of the contact closure feature in SLS mode.
Security is provided by limiting the number of users who know the correct key sequence
required for the contact closure feature.
• You cannot use the Hold or Transfer features while dialing the contact closure FAC key
sequence.
• Contact closure will not work until you dial the full digit sequence and it is processed.
• If two users try to simultaneously use contact closure, whoever dials the full FAC key
sequence first gets precedence.
• Interdigit timing rules apply to the contact closure feature, so if you pause too long during
the FAC key sequence, the feature times out.
• Call appearances are not released (available for calls) until you hang up.
• You cannot use the contact closure feature from outside trunk lines.
Note:
For more information on contact closure, refer to
Administering IP Softphone in SLS mode
About this task
The SLS mode supports shared administrative identity with the Avaya Softphone application,
but requires specific station administration.
Procedure
1. Access the Communication Manager administrative SAT interface.
2. At the SAT interface, enter change station extension to display the Station
3. Set the Terminal Type field to a 46xx IP phone.
4. Save the changes.
116 Administering Avaya G430 Branch Gateway
For instructions on accessing the Avaya Aura
the Avaya Branch Gateway, see
screen.
Note:
If you administer the Terminal Type field as a DCP phone, shared administrative
identity functionality in SLS mode is not supported.
Comments? infodev@avaya.com
Contact closure
®
Communication Manager through
Accessing the registered MGC
on page 317.
on page 72.
October 2013