Avaya G430 Manual page 177

2. Enter set dial dial-type, where dial-type is either rotary or dtmf.
3. Enter set tac tac, where tac is a 1 to 4 digit numeric value (plus initial # and *
4. Enter add port module port sig-group to specify the port that is compatible
Administering Avaya G430 Branch Gateway
• did (analog)
• ground-start (analog)
• bri (ISDN basic rate)
• t1-isdn (ISDN primary rate on 1.544 Mbps facility)
• e1-isdn (ISDN primary rate on 2.048 Mbps facility)
• t1-inband (non-ISDN rate on 1.544 Mbps facility)
• e1-inband (non-ISDN rate on 2.048 Mbps facility)
The command line prompt changes to super-sls/trunk-group-<tgnum>. If
you want to remove the trunk group from the SLS administration, enter exit to
leave the second-level trunk-group context and return to the (super-sls)# context,
and then enter clear trunk-group tgnum.
For example, set dial dtmf establishes that the trunk group uses DTMF
signaling.
on all but rotary dial phones) for this trunk's access code (TAC).
The TAC value must be unique among all trunk groups, extension numbers, and
ARS Feature Access Code (FAC) strings.
For example, set tac 88 establishes access to this trunk group by dialing "88".
with the device and/or media module.
The sig-group argument is necessary for a digital ISDN-PRI trunk. It is an integer
number from 1 to 650 that specifies the signaling group associated with the
management of this trunk member.
For more information, see
page 182.
Note:
Administer the signaling group and DS1 information before you add any ports to
the trunk group.
Example 1
If an MM711 is inserted into slot V3 and an analog loop-start trunk is to be
administered for port 4, then add port V304 administers an analog loop-start
trunk through port V304.
Example 2
If an MM722 is inserted into slot V2 and an ISDN BRI trunk is to be administered
for port 1, then add port v201 adds a BRI trunk for the first physical port of the
Maximum number of members in a trunk group
Standard Local Survivability (SLS)
October 2013
on
177