Avaya G430 Manual page 275

Log Message
PAP passed/
failed
CHAP passed/
failed
IPCP Up/Down
IPCP IP reject
Summary of modem dial backup commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level
command
interface
dialer
Administering Avaya G430 Branch Gateway
Severity Possible cause
request is sent, and goes down
when the link is terminated.
Debug This message is sent when the
authenticating station responds
to the PAP authentication
request.
Debug This message is sent when the
authenticating station responds
to the CHAP authentication
request.
Debug PPP uses IPCP to define the IP
characteristics of the session. IP
packets cannot be exchanged
until IPCP is in the Up state.
Warning This message is generated
when IPCP attempts to define
the IP characteristics for a PPP
session, but does not have the
IP address of the local interface
to define the session. Without IP
address information on both
sides of the session, the PPP
session cannot begin passing IP
traffic.
Command
dialer modem-
interface
None required.
None required.
None required.
Troubleshooting steps:
• Check Dialer
Description
Enter the Dialer interface configuration
context
Associate a Dialer with a modem interface
WAN interfaces
Action
interface
configuration to
ensure an IP address
is configured, either
as a static address or
through Dynamic IP
addressing or
through IP
unnumbered.
October 2013 275