Configuring The Wan Ethernet Port - Avaya G430 Manual

Ethernet ports
show port flowcontrol

Configuring the WAN Ethernet port

Procedure
1. Use the interface fastethernet 10/2 command to enter the context of the
2. Perform basic configuration of the interface.
3. Use the Ethernet WAN port configuration commands in the context of the port
Related topics:
Roadmap for configuring additional features on the WAN Ethernet port
WAN Ethernet port traffic shaping
About backup interfaces
Summary of WAN Ethernet port configuration CLI commands
Roadmap for configuring additional features on the WAN Ethernet port
• Primary Management Interface (PMI). For more information, see
Interface (PMI) configuration
• Advanced router features. For more information, see
• VoIP queuing. For more information, see
parameters
• Access control policy lists and QoS policy lists. For more information, see
page 557.
• SNMP Link Up and Link Down traps. For more information, see
configuration
WAN Ethernet port traffic shaping
You can use traffic shaping to determine the data transfer rate on the WAN Ethernet port. To
set traffic shaping, use the traffic-shape rate command in the interface context. To
202 Administering Avaya G430 Branch Gateway
Command
port interface.
For more information, see
interface.
See Summary of WAN Ethernet port configuration CLI commands
on page 203
on page 240.
on page 309.
Comments? infodev@avaya.com
Description
Display port flow control information
Interface configuration
on page 202
on page 64.
Commands used to configure QoS
on page 422.
on page 203.
on page 202
on page 203
Primary Management
The router on page 479.
Policy lists
SNMP trap
on
October 2013