Avaya G430 Manual page 70

Basic device configuration
Results from the set mgc list command
To determine the result of the set mgc list command, use the show mgc command. This
command has the following output:
Field
Registered
Active Controller
H248 Link Status
H248 Link Error Code
PRIMARY MGC HOST
SECONDARY MGC HOST
Showing the current MGC list
About this task
This command shows the IP addresses of the MGCs on the MGC list. It also shows whether
or not SLS is enabled.
Procedure
To show the current MGC list, use the show mgc list command.
Example
Gxxx-001(super)# sh mgc list
PRIMARY MGC HOST, Primary Search Time : 1 min(s)
IPv4 Address
-------------------- ----------------------------------------------
-- Not Available --
SECONDARY MGC HOST
IPv4 Address
-------------------- ----------------------------------------------
-- Not Available --
-- Not Available --
-- Not Available --
sls disabled
70 Administering Avaya G430 Branch Gateway
Description
Indicates whether or not the Branch Gateway
is registered with an MGC (YES or NO)
Displays the IP address of the active MGC.
If there is no active MGC (that is, if the
mgc list
MGC), this field displays
255.255.255.255
Indicates whether the communication link
between the Branch Gateway and the MGC
is up or down
If there is a communication failure between
the Branch Gateway and the MGC, this field
displays the error code
IPv4 and IPv6 addresses of the primary MGC
host
IPv4 and IPv6 addresses of the seconday
MGC hosts
IPv6 Address
100:0:0:0:0:0:0:803
IPv6 Address
-- Not Available --
-- Not Available --
-- Not Available --
Comments? infodev@avaya.com
command failed to configure an
.
set
October 2013