Avaya G430 Manual page 513

2. To set continuous channel for IKE phase 2, enter continuous-channel when
Full or partial mesh
This installation is very similar to the simple hub and spokes installation, but instead of
connecting to a single central site, the branch is also connected to several other branch sites
by direct IPSec VPN tunnels. The configuration is therefore very similar to the previous one,
duplicated several times.
In this topology:
• The Broadband Internet connection uses cable or DSL modem, with a static public IP
address
• There is a VPN tunnel from each spoke to the VPN hub over the Internet
• There is a VPN tunnel from one spoke to another spoke
• Only VPN traffic is allowed via the Internet connection
Administering Avaya G430 Branch Gateway
For example:
Gxxx-001# crypto isakmp peer address 149.49.70.1
Gxxx-001(config-peer:149.49.70.1)# continuous-channel
Done!
configuring the crypto map.
See Configuring crypto maps
For example:
Gxxx-001# crypto map 1
Gxxx-001(config-crypto:1)# continuous-channel
Done!
on page 493.
IPSec VPN
October 2013 513