Avaya G430 Manual page 225

Session log example
Commands used to set the logging filters
For each sink, you can set logging filters by specifying a severity level per application, as
follows:
• set logging server condition application severity ip address creates
a filter for messages sent to a specified Syslog server.
• set logging file condition application severity creates a filter for
messages sent to a log file.
• set logging session condition application severity creates a filter for
messages sent to a session log on a terminal screen where:
- application is the application for which to view messages (use all to specify all
applications). For the list of applications see
- severity is the minimum severity to log for the specified application (use none to
disable logging messages for the specified application). For a list of the severity
levels and the default severity settings, see
- ip address is the IP address of the Syslog server.
For example:
Gxxx-001(super)# set logging server condition dialer critical 147.2.3.66
Done!
Gxxx-001(super)# set logging file condition dhcps warning
Done!
Gxxx-001(super)# set logging session condition ISAKMP Information
Done!
You can also filter the show logging file content command by severity for each
application, using the same variables as in the set logging file condition command.
In addition, you can limit the number of messages to display.
For example, to display the 50 most recent messages from the QoS application with a severity
level of critical or higher, enter the following command:
Gxxx-001(super)# show logging file content critical qos 50
Severity levels
Severity level
emergency
alert
critical
Administering Avaya G430 Branch Gateway
on page 228
Code
0 System is unusable
1 Immediate action required
2 Critical condition
Application filtering
Severity levels on page 225.
Description
October 2013
System logging
on page 226.
225