Avaya G430 Manual page 174

Standard Local Survivability (SLS)
Country code
Country 13
(Germany)
ETSI
Administering BRI parameters
Procedure
1. Enter bri slot-address, where slot-address is any permitted port.
2. Enter set name name to identify the user name for the DS1 trunk.
3. Enter set interface glare-mode to specify the glare-handling convention.
4. If the BRI link is employed with ISDN, and the glare-handling convention is specified
174 Administering Avaya G430 Branch Gateway
German National PRI
ETSI
invalid
invalid
Full message set, including RESTART
No RESTART message
invalid
invalid
The command line prompt changes to sls-bri <slot-address>. If you want to remove
the BRI link from the SLS administration, enter exit to leave the second-level bri
context and return to the (super-sls)# context, and then enter clear bri slot-
address.
Use the 1-27 character name, as specified on Communication Manager (add
trunk-group n). Type the name string inside double quotes.
glare-mode can be one of the following values:
For non-QSIG calls:
• network. If the Branch Gateway is
connected to a host computer and
encounters glare, it overrides the
far-end
• user. If the Branch Gateway is
connected to a public network and
encounters glare, it releases the
circuit
as peerMaster or peerSlave for the ISDN link (set in Step 3), enter set side
side to specify the glare mode: either a or b.
Comments? infodev@avaya.com
Description
For QSIG calls:
• peerMaster. SLS overrides the other
end when glare occurs
• peerSlave. SLS releases the circuit
when glare occurs
Possible
Values
a
b
c
d
a
b
c
d
October 2013