Avaya G430 Manual page 243

Summary of WFVQ configuration CLI commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Root level
command
interface
(fastethernet
dialer)
show queueing
Administering Avaya G430 Branch Gateway
Command
|
fair-queue-
limit
fair-voip-
queue
priority-queue
show queue
voip-queue
Description
Enter the FastEthernet, or Dialer interface
configuration context
Specify the maximum number of packets
that can be queued in the weighted fair
queue. The upper and lower limits of this
command depend on the amount of
bandwidth configured for the interface.
Use this command only for troubleshooting.
Enable Weighted Fair VoIP Queuing
(WFVQ) on the current interface. WFVQ is
the recommended queuing mode for
interfaces.
The no form of the fair-voip-queue
command does not exist. If you enter the
command no fair-voip-queue
actually enable WFVQ if WFVQ is not
already enabled.
Enable or disable priority queuing mode in a
FastEthernet interface. If you disable priority
queuing, WFVQ is re-enabled.
Display information about the real-time
status of output queues for the current
interface
Enable or disable custom queueing for VoIP
traffic. If you disable custom queueing,
WFVQ is re-enabled.
Display the WFVG configuration
VoIP QoS
, it will
October 2013 243