Avaya G430 Manual page 416

Monitoring applications
Displaying and clearing profiles
Procedure
Use any of the following commands to display or clear profiles:
Launching and cancelling a test
About this task
Once you created a test profile, you can launch it when desired. However, due to memory
constraints on the analog media modules, only one test can be run at a time.
Note:
A test will fail if the port specified for the test is in use for a call, unless you specified set
destination none for this test profile.
Procedure
1. Enter analog-test to enter the analog-test context.
2. Use the launch command to launch a specific test.
Result
Note:
As soon as launch is issued, the results of previous measurements on the port are
cleared.
You can use the cancel command to abort an analog test that is currently running.
416 Administering Avaya G430 Branch Gateway
• In the analog-test-profile context, use the show command to display the test
profile.
• In the analog-test context, use the show profile command to display a
particular profile or all profiles.
• In the analog-test context, use the clear profile command to delete a
particular test profile or all profiles.
The port specified in the test profile must be busied out from Communication
Manager before the test is launched.
Comments? infodev@avaya.com
October 2013