Avaya G430 Manual page 570

Policy lists
Specifying fragments
Specifying DSCP
Composite operation instructions
Specifying IP protocol
Procedure
To specify the IP protocol to which the rule applies, enter ip-protocol followed by
the name of an IP protocol.
If you want the rule to apply to all protocols, use any with the command. If you want
the rule to apply to all protocols except for one, use the no form of the command,
followed by the name of the protocol to which you do not want the rule to apply.
Example
The following command specifies the UDP protocol for rule 1 in QoS list 401:
Gxxx-001(QoS 401/rule 1)# ip-protocol udp
The following command specifies any IP protocol except IGMP for rule 3 in access control list
302:
Gxxx-001(ACL 302/ip rule 3)# no ip-protocol igmp
Specifying a range of IP addresses
Procedure
To specify a range of source and destination IP addresses to which the rule applies,
use the commands source-ip and destination-ip, followed by the IP range
criteria.
Choose one of the following options as the IP range criteria:
570 Administering Avaya G430 Branch Gateway
on page 573
on page 573
• To specify a range, type two IP addresses to set a range of IP addresses to which
the rule applies
• To specify a single address, type host, followed by an IP address to set a single
IP address to which the rule applies
• To specify a wildcard, type host, followed by an IP address using wildcards to
set a range of IP addresses to which the rule applies
• To specify all addresses, type any to apply the rule to all IP addresses
Comments? infodev@avaya.com
on page 574
October 2013