Avaya G430 Manual page 431

Deleting a route and its next hops
Permanent static route
Discard routes
Summary of routing table commands
Next hops
Static routes can be configured with the following as next hops:
Next-hop IP address: Specifies the IP address of a router as a next hop. The next hop router
must belong to one of the directly attached networks for which the Branch Gateway has an IP
interface.
Static route types
Two kinds of static routes can be configured:
High Preference static routes: Preferred to routes learned from any routing protocol
Low Preference static routes: Used temporarily until the route is learned from a routing
protocol
By default, a static route has low preference.
Configuring multiple next hops
Procedure
You can configure up to three next hops for each static route in one of the following
manners:
If you apply tracking to a static route, you can only configure one next hop for the
route.
Administering Avaya G430 Branch Gateway
on page 432
on page 433
• Enter all of the next hops using a single ip route command. To add a new next
hop to an existing static route, enter the new next hop individually, as in the
following option.
• Enter each next hop individually with its own ip route command
Note:
on page 432
on page 433
The router
October 2013 431