Avaya G430 Manual page 253

3. Use the ip address command to configure an IP address and subnet mask for
4. Configure an authentication method and parameters:
5. If the Branch Gateway is connected to the Internet via the FastEthernet interface
6. Enter exit to return to general context.
7. Test the configuration.
8. Enter copy running-config startup-config to save the configuration.
9. Optionally, shut down the port and the PPPoE client, if configured, with the
Summary of PPPoE commands
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
Administering Avaya G430 Branch Gateway
the interface.
In most cases, PPPoE tunnels require a 32-bit subnet mask.
Alternatively, you can enter ip address negotiated to obtain an IP address
via PPP/IPCP negotiation.
Note:
You cannot configure PPP/IPCP address negotiation if DHCP address
negotiation is already configured on the interface (see
configuration on page 204).
• For PAP authenticating, enter ppp pap-sent username followed by a user
name and password. For example:
Gxxx-001(super-if:FastEthernet 10/2)# ppp pap-sent username avaya32
password 123456
Done!
• For CHAP authentication, enter ppp chap hostname followed by a
hostname, and ppp chap password followed by a password. For example:
Gxxx-001(super-if:FastEthernet 10/2)# ppp chap hostname avaya32
Done!
Gxxx-001(super-if:FastEthernet 10/2)# ppp chap password 123456
Done!
configured for PPPoE, and you define a VPN tunnel which specifies remote hosts
by name, it is recommended to use the ppp ipcp dns request command.
The command requests the list of available DNS servers from the remote peer
during the PPP/IPCP session. The DNS servers are used by the DNS resolver to
resolve hostnames to IP addresses.
The prompt returns to:
Gxxx-001(super)#
See WAN configuration and testing connectivity.
shutdown command in the interface context.
WAN interfaces
DHCP client
October 2013 253