Standard Local Survivability (SLS)
15. Enter show to check the BRI administration.
16. Enter exit to leave the bri context in SLS.
Trunk group assignment
You can create a trunk group that does not have any assigned members. Once a valid port is
assigned as a trunk group member, this trunk group then becomes active and may be
employed by SLS call processing for incoming/outgoing trunk operation. The slot-configuration
table is used, together with the port capacity for the given module, to determine the validity of
a port assignment at administration time.
As a result, there may not be more active trunk groups than there are physical trunk members
within a given Branch Gateway. In addition, a combo-port may only be used for one active
assignment. For example, the analog station/DID trunk ports may be either allocated to serve
as an analog station or as an analog DID trunk, but not both.
The maximum limits for a given trunk type are defined by the slot-configuration assignment for
the Branch Gateway. The maximum number of ports allowed per interface module is defined
in
SLS group type assignments
Example
trunk-group 1 loop-start establishes an analog loop-start trunk group number 1.
Administering trunk-group parameters
Procedure
1. Enter trunk-group tgnum group-type, where tgnum is any number from 1 to
176
Administering Avaya G430 Branch Gateway
Some European countries require that the physical layer is deactivated when there
is no active call.
The report lists the BRI parameters. For example:
Name = BRI-SLS1
BRI
Interface
Side
Stable
---
---------
----
-------------
v301
user
Dir-NumberA Dir-NumberB Spid-A
----------- ----------- -------------- --------------
3033234567
3033234568 30332345671111 30332345681111
on page 182.
2000 and group-type can be one of the following:
• loop-start (analog)
Comments? infodev@avaya.com
Country
Bearer
--------
------
a
country1 speech
Compand
Endpt-Init
-------
----------
ulaw
yes
Spid-B
Layer1-
yes
October 2013