Avaya G430 Manual page 121

2. At the SAT, enter change node-names ip to display the IP Node Names
3. In the Modem field, type v150mr.
4. Type the IP address of the Branch Gateway in the IP Address field.
5. Submit the screen.
6. At the SAT, enter change system-parameters mg-recovery-rule 1 to
7. Type a description of the rule in the Rule Name field.
8. Set the Migrate H.248 MG to primary field to immediately.
9. Submit the screen.
10. At the SAT, enter display media-gateway 1 to display the Media Gateway
11. Verify the following fields:
Administering Avaya G430 Branch Gateway
For instructions on accessing the Avaya Aura
the Branch Gateway, see
screen.
For example:
change ip-codec-set-1
Name
Denver Gateway1
procr
192.168.1 .201
(X of X administered node-names were displayed )
Use 'list node-names' command to see all the administered node-names
Use 'change node-names ip xxx' to change a node-name 'xxx' or add a node-
name
Note:
Set the name of the Branch Gateway consistently with the Name field on the
Media Gateway Administration screen in Communication Manager (add
media-gateway) and with the name used in the set system name command
(gateway CLI).
display the System Parameters Media Gateway Automatic Recovery Rule
screen.
Note:
The immediately value is only one of the four possible choices. See the
Administrator Guide for Avaya Aura
information on the values for this field.
screen.
• Name field (20 characters maximum) must match the administered name of
the gateway (see Step
the CLI on page 163).
Accessing the registered MGC
IP NODE NAMES
IP Address
192.168.1 .200
®
Communication Manager for more
2 on page 164 of
Standard Local Survivability (SLS)
®
Communication Manager through
on page 72.
Page
Name
. . .
Configuring the SLS data through
October 2013
1 of 3
IP Address
. . .
121