Avaya G430 Manual page 167

Administering branch gateway
Hide thumbs Also See for G430:
Table of Contents

Advertisement

3. For analog and dcp classes only (set in Step
4. Enter set cor cor to set the class of restriction (COR) for this extension, where
5. If this station is administered to be included into a pool of stations that are allowed
Administering Avaya G430 Branch Gateway
For example, set type ip4620 sets the previously-administered extension
"1234567" as an Avaya 4620 IP phone.
module-port for this station, where module-port is a value in
values in SLS station configuration mode
Note:
This command is required only for stations that support physical media module
ports.
If the class is ip (set in Step
You cannot select these modules or ports if they are already assigned as DID
trunks.
Examples:
• If an MM711 is inserted into slot V3 and an analog station is to be administered
for port #5, then set port v305 sets the previously-administered analog
station "1234567" to the fifth physical analog station port on the Branch
Gateway's media module.
• If an MM712 is inserted into slot V2 and a DCP station is to be administered
for port #1, then set port v201 sets the previously-administered dcp station
"1234567" to the first physical DCP station port on the Branch Gateway's
media module.
cor is one of the following:
• emergency
• internal (default)
• local
• toll
• unrestricted
There exists a hierarchical relationship among the calling-restriction categories. As
you move from the most restricted COR (emergency) to the least restricted
(unrestricted), each level increases the range of dialing abilities. For example, toll
includes the dialing privileges of local, internal, and emergency. See
of Restriction (COR) permissions
among the COR permissions.
For example, set cor unrestricted gives a station unrestricted dialing.
to receive incoming analog loop-start trunk calls, enter set trunk-destination
yes.
Standard Local Survivability (SLS)
1
on page 0
on page 169.
1
on page 0
), you cannot run this command.
on page 123 for the hierarchical relationship
), enter set port
Module-port
Inherited Class
October 2013
167

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents