Avaya G430 Manual page 178

Standard Local Survivability (SLS)
5. For an analog DID trunk group, enter set supervision sup-type to set the
6. For a non-ISDN digital trunk (t1-inband or e1-inband), enter set supervision
7. For an analog DID trunk group or DS1 non-ISDN tie trunk group, enter set digit-
178 Administering Avaya G430 Branch Gateway
Branch Gateway media module to a trunk group using one B-channel of the BRI
link.
Note:
You cannot mix BRI and PRI trunks within the same trunk group. If you attempt
to assign more than the maximum number of trunks to a trunk group, an error
message instructs you to delete a trunk member before adding a new trunk. A
physical trunk can be a member of only one trunk group.
incoming signaling supervision mode.
sup-type can be either immediate or wink.
For example, set supervision wink assigns wink-start incoming signaling
supervision to a DID trunk group.
sup-type to set the incoming signaling supervision mode, where sup-type can
be one of the following:
• loop-start
• ground-start
• wink-wink
• wink-immediate
• wink-auto
• immediate-immediate
• auto-auto
• auto-wink
treatment digit-treat, where digit-treat can be one of the following
values:
• blank (use this value to prevent any absorb or insert digit treatment from being
applied)
• absorb1
• absorb2
• absorb3
• absorb4
• absorb5
• insert1
• insert2
Comments? infodev@avaya.com
October 2013