Avaya G430 Manual page 85

To display the bank from which the Branch Gateway is currently set to load its firmware upon
startup or reset, use the show boot bank command.
Loading firmware from the non-default bank
About this task
Use the ASB button on the Branch Gateway front panel to load firmware from a bank other
than the default bank during startup:
Procedure
1. Press and hold the reset button.
2. Press and hold the ASB button.
3. Release the reset button.
4. Release the ASB button.
Result
For example, if the Branch Gateway is configured to load firmware from Bank B, use the steps
listed above to reset the Branch Gateway to load the firmware from Bank A instead.
Software and firmware upgrades using FTP/TFTP
To upgrade software or firmware, you must obtain an upgrade file from Avaya. Place the file
on your FTP or TFTP server. Then, use one of the following commands to upload the file to
the Branch Gateway. For each of these commands, include the full path of the file and the IP
address of the FTP or TFTP host as parameters. When you enter the command, the CLI
prompts you for a username and password.
When using FTP or TFTP commands, you must use the specific path of the file on the FTP or
TFTP server according to the home directory of the service (FTP or TFTP) that you are
using.
Example of an upgrade using FTP/TFTP
To upgrade the firmware of an MM710 media module in slot 2 from a TFTP server with the IP
address 192.1.1.10, where the home directory is c:\home\ftp\ and the upgrade file is located
in the directory c:\home\ftp\version, use the following command:
copy tftp module \version\mm710v3.fdl 192.1.1.10 2
Administering Avaya G430 Branch Gateway
Basic device configuration
October 2013 85