Avaya G430 Manual page 263

7. Configure an authentication method and parameters, if required:
8. From the general context, use show interfaces dialer 1 to verify that the
Administering Avaya G430 Branch Gateway
• Use the dialer persistent re-enable command to enable and
configure a timer to re-enable dial attempts after the maximum number of dial
attempts has been reached. For example:
Gxxx-001(if:dialer 1)# dialer persistent re-enable 3600
Done!
• Use the dialer order command to set which dial strings are used upon a
new dial trigger event. The default is to restart from the beginning of the dial
list. For example:
Gxxx-001(if:dialer 1)# dialer order last-successful
Done!
• Use the dialer persistent command to force the dialer to attempt to
reconnect every second, or at another redial interval, which you can configure
using the dialer persistent delay command. By default, redialing is
disabled. For example:
Gxxx-001(if:dialer 1)# dialer persistent
Done!
Gxxx-001(if:dialer 1)# dialer persistent delay 10
Done!
• Use the dialer wait-for-ipcp command to set the maximum time the
dialer waits between dialing a number to successfully establishing PPP/IPCP.
The default is 45 seconds. For example:
Gxxx-001(if:dialer 1)# dialer wait-for-ipcp 100
Done!
• For PAP authenticating, enter ppp pap sent-username followed by a
username and password. For example:
Gxxx-001(if:dialer 1)# ppp pap sent-username avaya32 password 123456
Done!
• For CHAP authentication, enter ppp chap hostname followed by a
hostname, and ppp chap password followed by a password. For example:
Gxxx-001(if:dialer 1)# ppp chap hostname avaya32
Done!
Gxxx-001(if:dialer 1)# ppp chap password 123456
Done!
Dialer interface has connected to the remote peer.
For example:
Gxxx-001(super)# show interfaces dialer 1
Dialer 1 is down, line protocol is down
Internet address is 4.5.6.7, mask is 255.255.255.0
MTU 1500 bytes, Bandwidth 28 kbit
IPSec PMTU: copy df-bit, Min PMTU is 300
Reliability 1/255 txLoad 255/255 rxLoad 255/255
Encapsulation PPP
Link status trap disabled
Keepalive track not set
Keepalive set (10 sec)
WAN interfaces
October 2013 263