Avaya G430 Manual page 573

The following command specifies any ICMP packet except type 1 code 2 for rule 5 in access
control list 321:
Gxxx-001(ACL 321/ip rule 5)# no icmp 1 2
Specifying TCP establish bit
About this task
This procedure is applicable to access control lists only.
Procedure
1. To specify that the rule only applies to packets that are part of an established TCP
2. Enter no tcp established to specify that the rule applies to all TCP packets.
Example
The following command specifies that rule 6 in access control list 301 only matches packets
that are part of an established TCP session:
Gxxx-001(ACL 301/ip rule 6)# tcp established
Specifying fragments
Procedure
Enter fragment to apply the rule to non-initial fragments.
You cannot use the fragment command in a rule that includes UDP or TCP source
or destination ports.
Gxxx-001(super-ACL 301/ip rule 5)# fragment
Done!
Gxxx-001(super-ACL 301/ip rule 5)#
Specifying DSCP
Procedure
1. Enter dscp, followed by a DSCP value (from 0 to 63), to apply the rule to all packets
Administering Avaya G430 Branch Gateway
session (a session in with the TCP ACK or RST flag is set), use the tcp
established command.
In either case, the command also sets the IP protocol parameter to TCP.
with the specified DSCP value.
Policy lists
October 2013 573