Avaya G430 Manual page 566

Policy lists
Attaching policy lists and QoS lists
Procedure
Choose one of the following commands:
For example, the following sequence of commands attach policy lists to the VLAN 2
interface. Access control list 301 becomes the ingress access control list for VLAN 2.
QoS list 401 becomes the egress QoS list for VLAN 2.
Gxxx-001# interface vlan 2
Gxxx-001(if:VLAN 2)# ip access-group 301 in
Done!
Gxxx-001(if:VLAN 2)# ip qos-group 401 out
Done!
Removing a list
Procedure
To remove a list from an interface, use the no form of the appropriate command.
For example, if the ingress access control list for the VLAN 1 interface is list number
302, you can remove the list from the interface by entering the following commands:
Gxxx-001(super)# interface vlan 1
Gxxx-001(super-if:VLAN 1)# no ip access-group in
Done!
You cannot change or delete a default list. You cannot change or delete any list
when it is attached to an interface. In order to change or delete a list that is attached
to an interface, you must first remove the list from the interface. You can then change
or delete the list. After changing the list, you can reattach the list to the interface.
566 Administering Avaya G430 Branch Gateway
• To attach a QoS list to an interface as its ingress QoS list, enter the interface
context and enter ip qos-group list number in.
• To attach an access control list to an interface as its egress QoS list, enter the
interface context and enter ip qos-group list number out.
Note:
Comments? infodev@avaya.com
October 2013