Avaya G430 Manual page 273

Log Message
Dialer 1 Modem
is not ready
USB Modem Messages
USB Modem Messages are messages generated by a USB modem.
Log Message
USB modem
was detected
Administering Avaya G430 Branch Gateway
Severity Possible cause
a timer is created. This timer
determines when the Dialer
interface attempts to begin
dialing again after a failure to
connect in as many attempts as
were configured in the dialer
persistent max-attempts
command. For example, if you
configured the value of dialer
persistent max-attempts as 10,
and dialer persistent re-enable is
configured for the Dialer
interface, after the Dialer has
made ten unsuccessful attempts
to connect to the remote
modem, the timer begins. When
the timer expires, the Dialer 1
timer expired message is sent,
and the Dialer begins attempting
to connect to the remote modem
again.
Warning This message is generated
when the Dialer interface has
been triggered and the
operational state of the Dialer is
up, but the Dialer is unable to
communicate with the modem.
Severity Possible cause
Informational When the USB modem is
discovered by the device and the
initialization string is successful,
a message is generated
indicating that the device is
ready to dial.
WAN interfaces
Action
Troubleshooting steps:
• Check modem cable
connection to port.
• Check modem cable
connection to
modem.
• Check power to
modem.
Action
None required.
October 2013 273