Avaya G430 Manual page 94

Basic device configuration
5. If the new Branch Gateway firmware version is below 26.x.y, you must replace it
6. If the new Branch Gateway firmware version is 26.x.y or above, add a Branch
7. Add the firmware files of the media modules to the USB mass-storage device, as
8. You can optionally add the firmware files of the IP phones to the USB mass-storage
1 46xxupgrade.txt
46xxupgrade.scr
2
94 Administering Avaya G430 Branch Gateway
with firmware version 26.x.y or higher, in order to enable the restore option.
To do so:
a. Download the Branch Gateway firmware from the Avaya support Website
(http://www.avaya.com/support) to an FTP/TFTP server.
b. Download the Branch Gateway firmware from the FTP/TFTP server to the new
Branch Gateway.
Assuming that Bank A holds the older firmware version, enter copy ftp
sw_imageA filename ip, where filename is the full path and file name of the
firmware file, and ip is the IP address of the FTP server. Alternatively, enter
copy tftp sw_imageA filename ip if you are downloading from a TFTP
server.
Gateway firmware to the USB mass-storage device, as follows:
a. From the Avaya support Website, download to your PC the same version of
Branch Gateway firmware as was running in the faulty Branch Gateway.
b. Insert the USB mass-storage device into the PC's USB port.
c. Copy the Branch Gateway firmware file to the root backup directory in the USB
mass-storage device.
follows:
a. From the Avaya support Website, download to your PC the firmware files of the
media modules installed in the gateway.
For each media module, download all firmware corresponding to the various
hardware vintage/suffix versions available for that module. If you are not sure
which media modules you have, you can download the firmware files of all
media modules. The restore operation uses only the files needed.
b. Insert the USB mass-storage device into the PC's USB port.
c. Copy the firmware files from the PC to the MM subdirectory in the USB mass-
storage device.
Do not change the firmware file names.
device, as follows:
a. From the Avaya support Website, download to your PC the firmware files
(booter and application) of up to two supported IP phones, as well as the
file.
b. Insert the USB mass-storage device into the PC's USB port.
c. Copy the IP phone files from the PC to the USB mass-storage device.
Comments? infodev@avaya.com
1 or 2
October 2013