Avaya G430 Manual page 49

2. Configure RADIUS authentication on the Branch Gateway.
RADIUS authentication configuration commands
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Command
clear radius
authentication
server
set radius
authentication
set radius
authentication
retry-number
set radius
authentication
retry-time
set radius
authentication
secret
set radius
authentication
server
set radius
authentication udp-
port
show radius
authentication
Administering Avaya G430 Branch Gateway
Description
Clear the primary or secondary RADIUS server IP address
Enable or disable RADIUS authentication
Set the number of times to resend an access request when
there is no response
Set the time to wait before resending an access request
Set the shared secret for RADIUS authentication
Set the IP address of the primary or secondary RADIUS
authentication server
Set the RFC 2138 approved UDP port number
Display all RADIUS authentication configurations (shared
secrets are not displayed)
Security overview
October 2013 49