Avaya G430 Manual page 146

Standard Local Survivability (SLS)
Name
Trunk Group Number
TAC
Port
Digit Treatment
Digits
Trunk Type
Group Name
Codeset to Send Display
Codeset to Send National IEs
146 Administering Avaya G430 Branch Gateway
Description
then the value of tone is used instead. Note
that this does not apply to DS1 PRI links.
This value is used in the routing table
This value is only necessary if the Dial
Access? field is set to y. If that field is set to
n, the TAC value is not pushed down to the
media gateway.
There may be more than one port within a
trunk group definition that pertains to a given
media gateway
This only applies for DID analog trunks or for
DS1 tie trunks. Note that this does not apply
to DS1 PRI tie trunks.
This field contains a value only when the
Digit Treatment field is set to insert1,
insert2, insert3, or insert4
Depends on trunk signaling type:
• Analog trunks:
- Loop-start
- Ground-start
- DID
• In-Band DS1 trunks with CO Group-Type:
- Loop-start
- Ground-start
• In-Band DS1 trunks with Tie Group-Type:
- Wink/wink
- Wink/immediate
- Wink/auto
- Immediate/Immediate
- Auto/auto
- Auto/wink
Customer identification of trunk group
Describes which Q.931 code-sets are
allowed to send Display IEs
Describes which Q.931 code-sets are
allowed to send National supported IEs
Comments? infodev@avaya.com
October 2013