Chapter 10: Modems And The Branch Gateway; Modems And The Branch Gateway; Usb-Modem Interface Configuration - Avaya G430 Manual

Chapter 10: Modems and the Branch

Modems and the Branch Gateway

You can connect a USB modem to the Branch Gateway. A USB modem must be connected
to the USB port on the Branch Gateway chassis.
The USB port requires configuration for modem use.
For more information about these commands, see the Avaya Branch Gateways G250 and
G350 CLI Reference.
For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
Note:
If you have an Avaya Service contract, no configuration of the USB port is necessary for
Services personnel to remotely access the Branch Gateway through a USB modem.
Related topics:

USB-modem interface configuration

USB-modem interface configuration
By default, the USB interface is enabled. Its default parameter values are:
• Interface status: = up
• PPP timeout absolute: = 10
• ppp authentication: = ras
• ip address: = 10.3.248.253 255.255.255.252
Related topics:
Example of IP address to USB port assignment
The ppp authentication command parameters
Summary of CLI commands for configuring the USB port for modem use
Administering Avaya G430 Branch Gateway
Gateway
on page 247
on page 248
on page 248
on page 248
October 2013 247