Avaya G430 Manual page 30

Accessing the Branch Gateway
Bandwidth commands:
----------------------------------------------------------------------
Syntax: bandwidth <kilobytes size>
Example: bandwidth 1000
CLI access using the local network
Access the CLI from a computer on the same local network as the Branch Gateway by using
SSH or, if Telnet is active, any standard Telnet program. Use the IP address of any Branch
Gateway interface for the host address.
CLI access using a PC device
To access the CLI with a PC device, connect a PC device to the Services port.
Related topics:
Accessing the gateway through the Services port
Accessing the gateway through the Services port
Procedure
1. Use a PC device with SSH client software.
2. Use an Ethernet cable to connect the PC device to the Services port on the front
3. Set the TCP/IP properties of the PC device as follows:
4. Configure the Internet browser settings of the PC device to disable the proxy
5. SSH to 192.11.13.6.
30 Administering Avaya G430 Branch Gateway
<kilobytes size> : integer (1-10000000)
panel of the Branch Gateway.
a. IP address = 192.11.13.5
b. Subnet mask = 255.255.255.252
c. Disable DNS service
d. Disable WINS Resolution
Note:
Make a record of any IP addresses, DNS servers, or WINS entries that you
change when you configure your laptop. Unless you use the NetSwitcher
program or an equivalent, you will need to restore these entries to connect to
other networks.
server.
Comments? infodev@avaya.com
on page 30
October 2013