Avaya G430 Manual page 393

For example:
Gxxx-001# show ip capture-list 511
Index Name
----- ------------------------------- --------------------------
511
Index Protocol
----- -------- --- ---------------- --------------- ------------
-------------
10
15
20
30
Deflt
Index Name
----- -------------------- ------------
0
1
Applying a capture list
Procedure
To apply a capture list, use the capture filter-group command from the general
context.
For example, to set the Branch Gateway to use capture list 511 on interfaces in which
packet sniffing is enabled, specify the following command:
Gxxx-001(super)# capture filter-group 511
Done!
Gxxx-001(super)#
Result
If no capture list is applied, the packet sniffing service captures all packets.
Configuring packet sniffing settings
About this task
The packet sniffing service provides several administrative settings you can use to control the
capture functionality. Use the following commands to configure packet sniffing settings. These
commands are all used from general context, and require read/write access.
Procedure
1. Use the capture buffer-mode command to specify the type of buffer to use.
Administering Avaya G430 Branch Gateway
list #511
IP
DSCP
tcp Src Any
Any Dst Any
tcp Src Any
Any Dst Any
tcp Src 135.122.50.171
Any Dst 135.122.50.128
Any Src 135.122.50.128
Any Dst 135.122.50.171
Any Src Any
Any Dst Any
Capture
No-Capture
The available parameters are:
Owner
other
Wildcard
Host
0.0.0.31
0.0.0.31
Host
Trust
No
No
Monitoring applications
Port Operation
Any No-Capture
eq Telnet
eq Telnet No-Capture
Any
Any Capture
Any
Any
Any
Any No-Capture
Any
October 2013 393