Reading The Relative Value From The Reference Point On The Trace - Agilent Technologies ENA Series User Manual

Data Analysis
Analyzing Data on the Trace Using the Marker
follows:
Softkey
All OFF
Marker 1
Ref Marker
NOTE In the preset configuration, the marker settings on traces in a channel are coupled (Marker
Couple is turned on). For marker coupling, refer to "Setting Up Markers for Each
Trace/Setting Up Markers for Coupled Operations Between Traces" on page 131.

Reading the Relative Value From the Reference Point on the Trace

You can convert the marker reading into a relative value from the reference point.
Figure 6-1 Delta marker mode
Converting From a Reference Point to a Relative Value
Step 1. Following Step 1 to Step 5 in "Reading Values on the Trace" on page 128, place the
reference marker on the point to be used as the reference.
Step 2. Press
With the reference mode turned on, the stimulus values and response values are indicated
in relative values referred to by the position of the reference marker.
Step 3. Following Step 4 to Step 5 in "Reading Values on the Trace" on page 128, place markers 1
through 9 on the desired points to read the values.
130
to
Marker 9
to turn on the reference mode.
Ref Marker Mode
Function
Turns off all of the markers on the active trace.
Turns off one of the markers 1 through 9 on
the active trace.
Turns off the reference markers on the active
trace.
Chapter 6