System Impedance (Z0) - Keysight Technologies FieldFox N9912A104 User Manual

Table of Contents

Advertisement

NA (Network Analyzer) Mode
NA Mode Settings
Nominal here means: a general, descritive term or design parameter. It is
not tested and not covered by the product warranty.
The Nominal Output displayed on the bottom right side of the display
indicates a range of low and high power values. Your actual measured
output power could be a little lower or a little higher.
If you have the USB power sensor feature (Option 302) you can measure
the actual output power for your measurement. Refer to
Mode (Option 302)" on page

System Impedance (Z0)

To accurately view data presented in Smith Chart format, first set the System
Impedance.
Learn how to select Smith Chart format in
Learn how to make 75Ω measurements at the FieldFox Supplemental Online
Help:
How to set System Impedance
— Press Meas Setup 4.
— Then Settings.
— Then scroll to System Z0 and press
— Then type either 50 or 75 and press Enter.
Keysight N9912-90001 User's Guide
— High (Default setting) Sets output power to the maximum achievable
power at all displayed frequencies. Please see the FieldFox
Specifications
(page
— Low Sets output power to approximately –27 dBm.
— Man Set output power to a arbitrary value.
— Then press
Nominal
— Then enter a value using the numeric keypad, the
rotary knob.
— Press Enter.
http://na.support.keysight.com/fieldfox/help/SupHelp/FieldFox.htm
B-3) for expected power levels.
Power.
11-1.
"Format" on page
Ed
it.
arrows, or the
"Power Meter
5-7.
5- 15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fieldfox n9912aFieldfox n9912a106

Table of Contents