Write - D-Link DES-7200 Cli Reference Manual

Chapter 2 Switch Management Configuration Commands
2.2.16

write

To perform the read/write operation for the device configurations (startup configuration or
system configuration), execute the privileged user command
write [ memory | network | terminal ]
Parameter
description
Command
mode
Usage
guidelines
Examples
2-22
DES-7210# show line console 0
CON Type speed
* 0 CON 9600
Line 0, Location: "", Type: "vt100"
Length: 24 lines, Width: 79 columns
Special Chars: Escape Disconnect Activation
^^x none
Timeouts: Idle EXEC
never
History is enabled, history size is 10.
Total input: 53564 bytes
Total output: 395756 bytes
Data overflow: 27697 bytes
stop rx interrupt: 0 times
Parameter Description
Write the system configuration (running-config)
memory into NVRAM, which is equivalent to copy
running-config startup-config.
Save the system configuration into the TFTP
network server, which is equivalent to copy
running-config tftp.
Show
terminal
equivalent to show running-config.
Privileged mode.
Despite of the alternative command, these commands have been
widely used and accepted, so they are reserved to facilitate user's
operation.
The no form with the command is equivalent to add the memory
operation.
The example below saves the device configuration:
DES-7210# write
DES-7200 CLI Reference Guide
Overruns
45927
^M
Idle Session
never
write
.
the system configuration, which is