Suzuki Baleno Manual page 1981

Sy413, sy416, sy418
Hide thumbs Also See for Baleno:
Table of Contents

Advertisement

WARNING:
For vehicles equipped with Supplement Restraint (Air Bag) System:
D Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "Air Bag System Components and Wiring Location View" un-
der "General Description" in air bag system section in order to confirm whether you are perform-
ing service on or near the air bag system components or wiring. Please observe all WARNINGS
and "Service Precautions" under "On-Vehicle Service" in air bag system section before perform-
ing service on or around the air bag system components or wiring. Failure to follow WARNINGS
could result in unintentional activation of the system or could render the system inoperative. Ei-
ther of these two conditions may result in severe injury.
D Technical service work must be started at least 90 seconds after the ignition switch is turned to
the "LOCK" position and the negative cable is disconnected from the battery. Otherwise, the sys-
tem may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
BATTERY
GENERAL DESCRIPTION
CARE OF BATTERY
. . . . . . . . . . . . . . . . . . . . . .
DIAGNOSIS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ON-VEHICLE SERVICE
. . . . . . . . . . . . . . . . . .
Jump Starting in Case of Emergency
OFF-VEHICLE SERVICE
Dismounting
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Handling
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remounting
. . . . . . . . . . . . . . . . . . . . . . . . . . .
SECTION 6H
CHARGING SYSTEM
CONTENTS
. . . . . . . . . . . . . . . .
6H- 2
6H- 3
6H- 4
6H- 5
. . . . .
6H- 5
. . . . . . . . . . . . . . . . .
6H- 6
6H- 6
6H- 6
6H- 6
GENERATOR
GENERAL DESCRIPTION
DIAGNOSIS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UNIT REPAIR OVERHAUL
Dismounting
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Remounting
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Disassembly
. . . . . . . . . . . . . . . . . . . . . . . . . .
Inspection
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Replace Brush
. . . . . . . . . . . . . . . . . . . . . . . . .
Reassembly
. . . . . . . . . . . . . . . . . . . . . . . . . . .
SPECIFICATIONS
. . . . . . . . . . . . . . . . . . . . . . .
TORQUE SPECIFICATION
CHARGING SYSTEM 6H-1
. . . . . . . . . . . . . . . .
6H- 7
6H- 9
. . . . . . . . . . . . . . . .
6H-12
6H-12
6H-13
6H-14
6H-17
6H-19
6H-20
6H-22
. . . . . . . . . . . . . . . .
6H-22
6H

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents