Suzuki Ignis Service Manual page 1737

6-3-78 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
Result Cause Of Fault
E11 • Short circuit to ground between:
Ignition Switch – Wiring harness connector (wiring harness side) terminal G24-2
&
Circuit Fuses – Input contact
E12 • Short circuit to ground between:
Ignition Switch – Wiring harness connector (wiring harness side) terminal G24-4
&
Circuit Fuses – Input contact
E13 • Short circuit to ground between:
Circuit Main Fuse – Output contact
&
Ignition Switch – Wiring harness connector (wiring harness side) terminal G24-5
E14 • If the nominal value is reached during one of the measurements, the component/control unit
that has been disconnected immediately before that measurement is defective.
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E15 • Short circuit to ground between:
Circuit Fuse – Output contact
&
ECM – Wiring harness connector (wiring harness side) terminal G88-23
&
Wiring harness connector terminals of all components (wiring harness side), which were discon-
nected from the wiring harness during this trouble shooting session
E16 • Circuit interruption between:
Circuit Fuse – Output contact
&
ECM – Wiring harness connector (wiring harness side) terminal G88-50
E17 • Circuit interruption between:
Circuit Fuse – Output contact
&
Data Link Connector – Wiring harness connector (wiring harness side) terminal G09-16
E18 • Circuit interruption between:
Circuit Main Fuse – Output contact
&
Circuit Fuse – Input contact
E19 • Circuit interruption between:
System Main Fuse – Output contact
&
Circuit Main Fuse – Input contact
E20 • Circuit interruption between:
Battery – Positive (+) terminal
&
System Main Fuse – Input contact
or
• Defective component:
Battery