Suzuki Ignis Service Manual page 1745

6-3-86 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
Test Work Order Description
T06 Check: Interruption of Voltage Supply Circuit
• Measure voltage between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal E27-4
&
Ground
Yes: T07
T07 Check: Interruption of Voltage Supply Circuit
• Measure voltage between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal E27-5
&
Ground
Yes: T08
T08 Check: Interruption of Voltage Supply Circuit
• Measure voltage between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal C66-5
&
Ground
Yes: T09
T09 Check: Component
• Remove fused jumper wire
• Insert electrical component in socket:
Main Relay
• Measure voltage between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal E27-80
&
Ground
Yes: T10
T10 Check: Component
• Connect fused jumper wire to:
ECM – Wiring harness connector (wiring harness side) terminal E27-80
&
Ground
• Measure voltage between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal E27-5
&
Ground
Yes: E01
T11 Check: Short to Voltage of Voltage Supply Circuit
• Remove electrical component from socket:
Circuit Fuse
• Measure voltage between the following terminals:
Main Relay – Socket Terminal E58-4
&
Ground
Yes: E08
Nominal Value
greater than 11 V
No: E05
greater than 11 V
No: T19
greater than 11 V
No: E04
greater than 11 V
No: E03
greater than 11 V
No: E02
less than 0.3 V
No: E09