Suzuki Ignis Service Manual page 1764

Test Work Order Description
T07 Check: Component
• Ignition OFF
• Connect fused jumper wire to:
Fuel Pump Relay – Socket terminal E52-4
&
Fuel Pump Relay – Socket terminal E52-3
Yes: T08
T08 Check: Component
• Insert electrical component in socket:
Fuel Pump Relay
• Ignition ON
• Connect fused jumper wire to:
ECM – Wiring harness connector (wiring harness side) terminal G88-75
&
Ground
Yes: E01
T09 Check: Interruption of Signal Circuit
• Disconnect wiring harness connector from:
Fuel Pump
• Measure voltage between the following terminals:
Fuel Pump – Wiring harness connector (wiring harness side) terminal
R02-3
&
Ground
Yes: T10
T10 Check: Circuit Interruption of Ground Circuit
• Measure resistance between the following terminals:
Fuel Pump – Wiring harness connector (wiring harness side) terminal
R02-4
&
Ground
Yes: E03
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-105
Nominal Value
Is the fuel pump run-
ning?
No: T09
Is the fuel pump run-
ning?
No: E02
greater than 11 V
No: E05
less than 5 Ohm
No: E04