Deleting A Traffic Control Priority; Managing Traffic Control Classes - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Parameter
interface { interface }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.39.3.3

Deleting a Traffic Control Priority

To delete a traffic control priority, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control priority by typing:
no qos traffic-control basic-configuration tcpriority name
Where:
• name is the name of the traffic control priority entry
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.39.4

Managing Traffic Control Classes

Traffic control classes define classes for traffic shaping. Optionally, they can also define parameters for Type
of Service (ToS), which is an eight-bit field in the IPv4 header. Traffic control can inspect the ToS value of an
incoming IP frame and classify traffic to provide preferential service in the outgoing queue. Traffic classification is
done based on the ToS value and the ToS options defined for each traffic control class and traffic control rule. IP
Traffic matching with the ToS options takes precedence over the mark rules.
NOTE
One traffic control class must be added for each network interface.
NOTE
Type of Service (ToS) is defined by the Internet Engineering Task Force (IETF). For more information
about ToS, refer to
572
RFC 1349 [http://tools.ietf.org/html/rfc1349].
Description
(choice) The source address. This can be specified <emphasis
role="bold">only if</emphasis> the protocol, port and interface
are not defined.
Prerequisite: An address can be specified only if neither a
protocol or port nor an interface are specified.
Synopsis: A string 1 to 15 characters long
(choice) The source interface. This can be specified <emphasis
role="bold">only if</emphasis> the protocol, port and address
are not defined. Lowercase alphanumerical as well as '.' and '-'
characters are allowed.
Prerequisite: An interface can be specified only if neither a
protocol, port nor an address are specified.
Synopsis: A string
(optional) A description for this configuration.
RUGGEDCOM ROX II
CLI User Guide
Deleting a Traffic Control Priority