Chapter 3
Device Management
Section 3.24.5.2
Viewing a List of Virtual Switch Filters
To view a list of virtual switch filters, type:
show running-config security virtualswitch-filter virtualswitch
If filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security virtualswitch-filter virtualswitch | tab
IF
NAME
NAME
ROUTE
----------------------------------------------
vs1
arp
X
ipv4
X
ipv6
-
iso
-
goose
-
!
!
If no virtual switch filters have been configured, add filters as needed. For more information, refer to
Section 3.24.5.3, "Adding a Virtual Switch
Section 3.24.5.3
Adding a Virtual Switch Filter
To add a virtual switch filter, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Make sure one or more virtual switches are configured. For more information, refer to
"Adding a Virtual
3.
Add the virtual switch filter by typing:
security virtualswitch-filter virtualswitch interface
Where:
• interface is a virtual switch interface
4.
Configure one or more rules to be used when filtering. For more information, refer to
"Adding a
Rule".
5.
Add the desired rules to the virtual switch filter. For more information, refer to
Rule to a Virtual Switch
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
150
NAME
NAME
switch.0010
switch.0020
switch.0010
switch.0020
switch.0010
switch.0020
Filter".
Switch".
Filter".
RUGGEDCOM ROX II
CLI User Guide
Section 3.24.2,
Section 3.24.6.3,
Section 3.24.6.4, "Adding a
Viewing a List of Virtual Switch Filters