RUGGEDCOM ROX II
CLI User Guide
If entries have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf filter route-map map entry | tab
NEXT
SEQ
ACTION
CALL
OPERATION
VALUE
---------------------------------------------------------------------------------------------
10
permit
-
-
-
!
!
If no filters have been configured, add filters as needed. For more information, refer to
a Route Map Filter
Section 5.21.6.3
Adding a Route Map Filter
To add a route map filter for dynamic OSPF routes, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the new filter by typing:
• For Standard OSPF Routes
routing ospf filter route-map tag
• For VRF Routes via OSPF
routing ospf vrf vrf filter route-map tag
Where:
• vrf is the name of the chosen VRF
• tag is the tag for the route map filter
3.
Add one or more entries. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.21.6.4
Adding a Route Map Filter Entry
To add an entry for an route map filter, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the new filter by typing:
• For Standard OSPF Routes
routing ospf filter route-map tag entry number
• For VRF Routes via OSPF
routing ospf vrf vrf filter route-map tag entry number
Where:
Adding a Route Map Filter
ON
MATCH
AS
PREFIX
ORIGINATOR
GOTO
PATH
LIST
HOP
ORIGIN
ID
-
-
-
-
-
Entry".
PREFIX
PREFIX
LIST
LIST
METRIC
WEIGHT
AS
-
-
-
-
Section 5.21.6.4, "Adding a Route Map Filter
Setup and Configuration
PEER
ORIGIN
AS
IP
-
-
-
-
Section 5.21.6.4, "Adding
Chapter 5
LOCAL
PREFERENCE
-
-
Entry".
369