Table of Contents
Advertisement
Chapter 5
Setup and Configuration
!
If no custom client options have been configured, add options as needed. For more information, refer to
Section 5.15.8.2, "Adding a Custom Client
Section 5.15.8.2
Adding a Custom Client Option
To add a custom client option to a DHCP subnet, do the following:
NOTE
The number of the option (defined by the Internet Assigned Numbers Authority or IANA) and its
allowed value must be known before this custom option can be configured. For more information about
DHCP options, refer to
1.
Make sure the CLI is in Configuration mode.
2.
Add the custom client option by typing:
services dhcpserver subnet name options client custom number value
Where:
• name is the name of the subnet
• number is the number defined by the Internet Assigned Numbers Authority (iANA) for the custom client
option
• value is the value of the custom client option
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.15.8.3
Deleting a Custom Client Option
To delete a custom client option for a DHCP subnet, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the custom client option by typing:
no services dhcpserver subnet name options client custom number value
Where:
• name is the name of the subnet
• number is the number defined by the Internet Assigned Numbers Authority (iANA) for the custom client
option
• value is the value of the custom client option
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
248
Option".
RFC 2132
[http://tools.ietf.org/html/rfc2132].
RUGGEDCOM ROX II
CLI User Guide
Adding a Custom Client Option
Advertisement
Table of Contents
Troubleshooting
