Managing Logs - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
1. If the file's destination is a USB Mass Storage drive, insert the drive in the USB port on the device. For more
information, refer to the RUGGEDCOM RX1500/RX1501/RX1510/RX1511/RX1512 Installation Guide.
2. Make sure the CLI is in Configuration mode.
Navigate to admin » backup-files and configure the following parameter(s) as required:
3.
Parameter
file-type { file-type }
file { file }
timestamp
url { url }
Section 3.9

Managing Logs

RUGGEDCOM ROX II maintains various logs to record information about important events. Each log falls into
one of the following log types:
Security Event Logs
Syslogs
Managing Logs
Information related to the following security events are logged by RUGGEDCOM ROX II:
NOTE
Passwords can be retried up to 3 times before the login attempt is considered a security event.
• Successful and unsuccessful login attempts
• Local and remote (RADIUS) authentication
• Security-sensitive commands (whether successful or unsuccessful)
• An optionally configurable SNMP Authentication Failure Trap (disabled by default) in accordance with
SNMPv2-MIB
All security event logs are recorded in var/log/auth.log and can be viewed in the Authlog Viewer. For
more information about viewing logs, refer to
Syslog allows users to configure local and remote syslog connections to record important, non-security event
information. The remote Syslog protocol, defined in
IP-based transport that enables a device to send event notification messages across IP networks to event
message collectors, also known as Syslog servers. The protocol is designed to simply transport these event
messages from the generating device to the collector.
Description
Synopsis: { config, featurekey, logfiles, rollbacks, licenses }
The file types to copy.
Synopsis: A string 1 to 255 characters long
The file names to copy.
Synopsis: true or false
Default: false
If enabled, a time stamp will be appended to the file name. This
option is not applicable to file names that contain '*'.
Synopsis: A string 1 to 1024 characters long
The URL of the ROX II file to copy. Supported URIs are HTTP,
SCP, SFTP, FTPS and FTP. To save to a USB flash drive or
microSD/microSDHC drive (if applicable), the URL format is
"usb://<usb-device-name>/path-to-file-on-system" or "sd://sd-1//
path-to-file-on-system". Run "show chassis" to determine the
name of the USB device. Note that only one single partition is
supported for either data medium. For all other protocols, the
format is "protocol://user:password@host:port/path-to-file". If
using a path only, close it with '/'. If "port" is not specified, the
default port for the protocol is used.
Section 3.9.1, "Viewing Logs".
RFC 3164 [http://tools.ietf.org/html/rfc3164], is a UDP/
Chapter 3
Device Management
59