Managing Static Mac Addresses; Viewing A List Of Static Mac Addresses; Adding A Static Mac Address - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.35.4

Managing Static MAC Addresses

Static MAC addresses must be configured when the device is only able to receive frames, not transmit them.
They may also need to be configured if port security (if supported) must be enforced.
Prioritized MAC addresses are configured when traffic to or from a specific device on a LAN segment is to be
assigned a higher CoS priority than other devices on that LAN segment.
The following sections describe how to configure and manage static MAC addresses:
• Section 5.35.4.1, "Viewing a List of Static MAC Addresses"
• Section 5.35.4.2, "Adding a Static MAC Address"
• Section 5.35.4.3, "Deleting a Static MAC Address"
Section 5.35.4.1

Viewing a List of Static MAC Addresses

To view a list of static MAC addresses configured on the device, type:
show running-config switch mac-tables static-mac-table
If static MAC addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config switch mac-tables static-mac-table | tab
MAC
------------------------------------------------------
00:0a:dc:f6:8b:ff
00:10:94:00:24:01
00:10:94:00:30:01
00:10:94:00:40:01
!
If no static MAC addresses have been configured, add addreses as needed. For more information, refer to
Section 5.35.4.2, "Adding a Static MAC
Section 5.35.4.2

Adding a Static MAC Address

To add a static MAC address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the static MAC address by typing:
Managing Static MAC Addresses
Description
not aged-out, the switch will still be forwarding traffic to that port, thus preventing that
traffic from reaching its destination via the new network topology. This parameter allows
the aging-out of all MAC addresses learned on a failed port immediately upon link failure
detection.
VID LEARNED SLOT PORT
4085 - lm1 2
4084 - lm1 1
1 - lm1 2
4086 - lm1 2
Address".
COS
normal
normal
normal
normal
Chapter 5
Setup and Configuration
511