RUGGEDCOM ROX II
CLI User Guide
Section 5.29.10.2
Viewing a List of Addresses for Private Subnets
To view a list of addresses configured for private subnets, type:
show running-config tunnel ipsec connection connection { right | left } subnet
Where:
• connection is the name of the connection
If addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config tunnel ipsec connection ipsec-12 left subnet
tunnel
ipsec
connection ipsec-12
left
subnet 192.168.11.0/24
!
!
!
!
!
If no addresses have been configured, add addresses as needed. For more information, refer to
Section 5.29.10.3, "Adding an Address for a Private
Section 5.29.10.3
Adding an Address for a Private Subnet
To add a new address for a private subnet, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the address by typing:
tunnel ipsec connection connection [ right | left ] subnet address
Where:
• address is the address and prefix of the private subnet
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.29.10.4
Deleting an Address for a Private Subnet
To delete an address for a private subnet, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the address by typing:
no tunnel ipsec connection connection { right | left } subnet address
Where:
• address is the address and prefix of the private subnet
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Viewing a List of Addresses for Private Subnets
Subnet".
Chapter 5
Setup and Configuration
473