Viewing A List Of Option 82 Classes For Ip Pools; Adding An Option 82 Class To An Ip Pool - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.15.16.1

Viewing a List of Option 82 Classes for IP Pools

To view a list of Option 82 classes configured for an IP pool, type:
show running-config services dhcpserver subnet name options ippool description option82
Where:
• name is the name of the subnet
• description is the name of the IP pool
If classes have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver subnet Local options ippool pool1 option82
services
dhcpserver
subnet Local
options
ippool pool1
option82 class1
remote-id
circuit-id 00:00:00:01:01:01
!
!
!
!
!
!
If no Option 82 classes have been configured, add classes as needed. For more information, refer to
Section 5.15.16.2, "Adding an Option 82 Class to an IP
Section 5.15.16.2

Adding an Option 82 Class to an IP Pool

To add an Option 82 class to an IP pool, do the following:
NOTE
The format for the circuit-id value is 00:00:00:{vlan}:{slot}:{port}. If the remote host is connected to
LM3/1 on VLAN 1, the ID would be 00:00:00:01:03:01.
1. Make sure the CLI is in Configuration mode.
2. Add the pool by typing:
services dhcpserver subnet name options ippool description option82 class
Where:
• name is the name of the subnet
• description is the name of the IP pool
• class is the name of the Option82 class
3. Configure the following parameter(s) as required:
Parameter
remote-id { remote-id }
Viewing a List of Option 82 Classes for IP Pools
00:00:00:01:03:01
Pool".
Description
Synopsis: A string
Chapter 5
Setup and Configuration
263