Chapter 3
Device Management
Parameter
fail-count
Section 3.17.8.3
Clearing Cable Diagnostic Statistics
The following describes how to clear the statistics collected when cable diagnostic tests are performed. All of the
statistics or only those for a specific switchport can be cleared.
Clearing All Cable Diagnostic Statistics
To clear the statistics, type:
switch clear-cable-stats-all
Clearing Cable Diagnostic Statistics for a Specific Switchport
To clear only the statistics for a specific switchport, type:
interfaces switch slot port diagnostics clear-cable-stats-port
interfaces switch swport port diagnostics clear-cable-stats-port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Section 3.18
Managing Routable Ethernet Ports
The following sections describe how to configure and manage routable Ethernet ports:
•
Section 3.18.1, "Viewing a List of Routable Ethernet Ports"
•
Section 3.18.2, "Configuring a Routable Ethernet Port"
Section 3.18.1
Viewing a List of Routable Ethernet Ports
To view a list of routable Ethernet ports, type:
show running-config interface eth
A table or list similar to the following example appears:
ruggedcom# show running-config interface eth
interface
eth cm 1
auton
no proxyarp
104
Description
Failure Count
Clearing Cable Diagnostic Statistics
RUGGEDCOM ROX II
CLI User Guide