Deleting A Qos Map - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For Routable-Only Ethernet Ports
interface eth slot port vlan id qosmap priority
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For Virtual Switches
interface virtualswitch id vlan
Where:
▪ id is the ID of the virtual switch
▪ vlan-id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For WAN Interfaces
interface wan interface protocol channel number connection hdlc-eth vlan id qosmap priority
Where:
▪ interface is the WAN interface
▪ protocol is either T1 or E1
▪ number is the channel number
▪ id is the ID of the VLAN
▪ priority is the priority assigned to the QoS map
3. Configure the following parameter(s) as required:
Parameter
ingress { ingress }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.39.7.3

Deleting a QoS Map

To delete a QoS map for a VLAN connection, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the QoS map for the VLAN connection by typing:
Deleting a QoS Map
vlan-id qosmap priority
Description
Synopsis: An integer between 0 and 255
Map the ingress to a mark.
Chapter 5
Setup and Configuration
585