Managing Snmp Group Access; Viewing A List Of Snmp Groups; Adding An Snmp Group - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
• model is the security model
• name is the name of the user
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.11.9

Managing SNMP Group Access

The following sections describe how to configure and manage SNMP group access:
• Section 5.11.9.1, "Viewing a List of SNMP Groups"
• Section 5.11.9.2, "Adding an SNMP Group"
• Section 5.11.9.3, "Deleting an SNMP Group"
Section 5.11.9.1

Viewing a List of SNMP Groups

To view a list of SNMP groups configured on the device, type:
show running-config admin snmp snmp-access
If groups have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-access | tab
SECURITY
GROUP MODEL
------------------------------------------------------------------------
initial any
initial any
initial any
testgroup v2c
all-rights any
!
!
If no SNMP groups have been configured, add groups as needed. For more information, refer to
"Adding an SNMP Group".
Section 5.11.9.2

Adding an SNMP Group

To add an SNMP group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the SNMP group by typing:
admin snmp snmp-access group model level
Where:
• group is the name of the group
• model is the security model for the group
214
SECURITY READ VIEW
LEVEL NAME
noAuthNoPriv all-of-mib
authNoPriv all-of-mib
authPriv all-of-mib
noAuthNoPriv all-of-mib
noAuthNoPriv all-of-mib
WRITE VIEW NOTIFY
NAME VIEW NAME
all-of-mib all-of-mib
all-of-mib all-of-mib
all-of-mib all-of-mib
all-of-mib all-of-mib
all-of-mib all-of-mib
RUGGEDCOM ROX II
CLI User Guide
Section 5.11.9.2,
Managing SNMP Group Access