Viewing A List Of Snmp Users; Adding An Snmp User - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
• Section 5.11.7.3, "Deleting an SNMP User"
Section 5.11.7.1

Viewing a List of SNMP Users

To view a list of SNMP users configured on the device, type:
show running-config admin snmp snmp-user
If users have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-user | tab
USER ENGINE ID
--------------------------------------------------------------------------------
80:00:3a:9c:03:00:0a:dc:ff:9a:00
80:00:3a:9c:03:00:0a:dc:ff:9a:00
80:00:3a:9c:03:00:0a:dc:ff:9a:00
!
!
If no SNMP users have been configured, add users as needed. For more information, refer to
"Adding an SNMP User".
Section 5.11.7.2

Adding an SNMP User

To add an SNMP user, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the SNMP user by typing:
admin snmp snmp-user id name
Where:
• id is the ID for the user
• name is the name of the user
3. Configure the following parameter(s) as required:
Parameter
{ user-engine-id }
{ user-name }
auth-protocol { auth-protocol }
auth-key { auth-key }
Viewing a List of SNMP Users
USER AUTH
NAME PROTOCOL AUTH KEY
oper sha1 $4$kNxlPIYMx2xJhYYI0d4IDw==
admin none -
guest md5 $4$kNxlPIYMx2xJhYYI0d4IDw==
Description
Synopsis: A string
The administratively-unique identifier for the SNMP engine; a value in the format
nn:nn:nn:nn:nn:...:nn, where nn is a 2-digit hexadecimal number. The minimum length is
5 octets. The maximum length is 32 octets. Each octet must be separated by a colon (:).
The user for the SNMP key. Select a user name from the list.
Synopsis: { none, md5, sha1 }
Default: none
The authentication protocol providing data integrity and authentication for SNMP
exchanges between the user and the SNMP engine.
Synopsis: A string
Chapter 5
Setup and Configuration
Section 5.11.7.2,
211