Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Parameter
start-delay { start-delay }
main-down-timeout { main-down-timeout }
main-up-timeout { main-up-timeout }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.28.3.3
Deleting a Link Failover Parameter
To delete a link failover parameter, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the parameter by typing:
no services link-failover interface
Where:
• interface is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.28.4
Managing Link Failover Backup Interfaces
A backup interface is the interface to which link failover switches when the main interface is determined to be
down. You can add up to three backup interfaces to each link failover configuration.
The following sections describe how to configure and manage backup interfaces for link failover protection:
•
Section 5.28.4.1, "Viewing a List of Link Failover Backup Interfaces"
•
Section 5.28.4.2, "Adding a Link Failover Backup Interface"
•
Section 5.28.4.3, "Deleting a Link Failover Backup Interface"
Section 5.28.4.1
Viewing a List of Link Failover Backup Interfaces
To view a list of link failover backup interfaces, type:
Deleting a Link Failover Parameter
Description
The number of ping retries before constructing a path failure.
Synopsis: An integer between 0 and 65536
Default: 180
The delay time, in seconds, when first starting link failover.
Synopsis: An integer between 0 and 65536
Default: 60
The delay time, in seconds, that the main trunk is down before
starting the backup trunk.
Synopsis: An integer between 0 and 65536
Default: 60
The delay time, in seconds, to confirm that the main trunk is up
(returned to service) before stopping the backup trunk.
Chapter 5
Setup and Configuration
451
Advertisement
Table of Contents
Troubleshooting
